Weider Pro 4900 English Manual - Page 19

51. Route the Right Stack Cable (70) down through 51 the Right Top Frame (7) and over a 90mm Pulley (39). Attach the Pulley and a Small Cable Trap (48) inside the Top Frame with an M10 x 80mm Bolt (111), two M10 Washers (116), a 19mm Spacer (77), a 16mm Spacer (124), and an M10 Nylon Locknut (114). Make sure the 16mm Spacer and the Small Cable Trap are on the same side of the Pulley. 52. Set an M12 Washer (129) on top of the Long 52 Weight Tube (36). Thread an M12 Nut (128) all the way onto the Right Stack Cable (68). Thread the Right Stack Cable (68) into the Long Weight Tube (36). Tighten the M12 Nut (128) against the M12 Washer (129). 114 77 116 39 124 116 111 7 68 48 68 128 129 36 53. Locate the Press Cable (69). Grease an M8 x 86mm Shoulder Bolt (86). Attach the Cable to the Leg Press Frame (12) with the Bolt, an M8 Washer (117) and an M8 Nylon Locknut (115). 54. Wrap the Press Cable (69) around a 90mm Pulley (39). Attach the Pulley, two Half Finger Guards (42), a Small Cable Trap (48), and an M10 Washer (116) to the Left Seat Frame (10) with an M10 x 103mm Bolt (106), an M10 Washer (116), and an M10 Nylon Locknut (114). Make sure the Cable Trap and Finger Guards are oriented as shown. 55. Wrap the Press Cable (69) around a "V"-pulley (40). Attach the "V"-pulley, two Half Finger Guards (42), and two M10 Washers (116) to the Leg Press Frame (12) with an M10 x 118mm Bolt (100), an M10 Washer (116), and an M10 Nylon Locknut (114). Make sure the Finger Guards are oriented as shown. 53 117 69 86 115 12 54 114 116 10 42 48 42 69 106 39 116 55 116 114 12 69 40 42 100 116 116 42 19