Weider Pro 7500 Uk Manual - Page 21
Identify the Leg Lever Cable 51.
View all Weider Pro 7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
42. Route the Press Cable (133) under a 90mm 42 Pulley (48). Attach the Pulley and a Cable Trap (56) to the Left Frame (122) with an M10 x 116mm Bolt (107), two Half Guards (55), an M10 Washer (80), and an M10 Nylon Locknut (77). Make sure the Cable Trap and the Half Guards are oriented as shown. 122 77 133 80 55 107 55 56 48 43. Route the Press Cable (133) under a 90mm Pulley (48). Attach the Pulley to the Left Base 43 (119) with an M10 x 50mm Bolt (97), two Half Guards (55), and an M10 Nylon Locknut (77). Make sure the Half Guards are oriented as shown. 55 77 48 97 55 133 44. Attach the Press Cable (133) to the "U"-bracket (151) with an M8 Washer (103) and an M8 Nylon Locknut (78). See the inset drawing. Do not completely tighten the Nylon Locknut; it should be tightened so that only two threads of the Cable show past the Nylon Locknut. 44 151 78 119 78 151 103 133 133 45. Identify the Leg Lever Cable (51). Route the 45 Cable through the Leg Lever (12) and the Front 12 48 Bar 2 Leg (10), under the indicated bar, and through the Right Upright (2). Insert a 90mm Pulley (48) into the Leg Lever (12) from the indicated direction. Attach the Pulley to the Leg Lever with an M10 x 68mm Bolt (85), two M10 Washers (80), two 13mm Steel Spacers (109), and an M10 Nylon Locknut (77). 85 80 109 51 109 10 80 77 21