Weslo Momentum Ct5.8 Elliptical English Manual - Page 10

10. Identify the Left Pulse Bar (90), which is marked with a "Left" sticker. Orient the Left Pulse Bar so that the hexagonal holes are in the indicated location. Have another person hold the Left Pulse Bar (90) near the Upright (2). See the inset drawing. Locate the wire tie in the Upright (2). Tie the lower end of the wire tie to the left Pulse Wire (96). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: Avoid pinching the wires. Slide the Left Pulse Bar (90) onto the left side of the Upright (2). Attach the Left Pulse Bar with two M8 x 38mm Button Bolts (94) and two M8 Locknuts (59). Make sure that the Locknuts are in the hexagonal holes. Repeat this step for the Right Pulse Bar (91). 10 Wire Ties 94 2 96 90 59 Avoid pinching the wires Wire Tie 96 96 91 Hexagonal Holes 11. The Console (10) can use four AA batteries (not 11 included); alkaline batteries are recommended. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console dis- plays or other electronic components. Remove the battery cover, insert the batteries into the battery compartment, and reattach the battery cover. Make sure to orient the batteries as shown by the dia- gram inside the battery compartment. Do not combine old and new batteries or alkaline and rechargeable batteries. Screw Battery Cover 10 Batteries 10