Whirlpool WED7990FW Installation Guide - Page 11
Direct Wire Connection
View all Whirlpool WED7990FW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
2. Connect neutral wire Direct Wire Connection B C Connect neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw. 3. Connect remaining wires Direct wire strain relief 1. Attach direct wire strain relief Connect remaining wires under outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover A into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Connect Outlet Hose." B C Unscrew the removable conduit connector (A) and any screws from a 3/4" (19 mm) UL-listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief (C) through the hole below the terminal block opening (B). Reaching inside the terminal block opening, screw the removable conduit connector (A) onto the strain relief threads, and tighten securely. 11