Whirlpool WED7990FW Installation Guide - Page 3

Installation Requirements TOOLS AND PARTS Gather the required tools and parts before starting installation. Tools needed: Parts supplied: Flat-blade screwdriver #2 Phillips screwdriver Leveling legs (4) 6' (1829 mm) drain hose with couplers Wire stripper (direct wire installations) Channel locks 1/4" and 5/16" nut driver (recommended) Adjustable wrench that opens to 1" (25 mm) or hex-head socket wrench Cable ties (2) Parts package is located in dryer drum. Check that all parts are included. NOTE: Do not use leveling legs supplied with dryer if installing with a pedestal or a stack kit. If using a power supply cord: Use a UL-listed power supply cord kit marked for use with clothes dryers. The kit should contain: ■■A UL-listed 30-amp power supply cord, rated 120/240 volt minimum. The cord should be type SRD or SRDT and be at least 4 ft. (1.22 m) long. The wires that connect to the dryer must end in ring terminals or spade terminals with upturned ends. ■■A UL-listed strain relief. Additional Accessories: (Not supplied with dryer) Refer to your Use and Care Guide for information about accessories available for your dryer. Utility knife Tape measure Level Pliers 3