Whirlpool WED7990FW Installation Guide - Page 8

Install Leveling Legs 1. Prepare dryer for leveling legs Electric Installation - U.S.A. Only Before you start: disconnect power. 1. Choose electrical connection type Power supply cord 4-wire receptacle (NEMA Type 14-30R). Go to "Power Supply Cord Connection." Power supply cord 3-wire receptacle (NEMA Type 10-30R). Go to "Power Supply Cord Connection." To avoid damaging floor, use a large flat piece of cardboard from dryer carton; place under entire back edge of dryer. Firmly grasp dryer body (not console panel) and gently lay dryer down on cardboard. NOTE: Residual water from factory testing may drain when dryer is laying on its side. 2. Screw in leveling legs 4-wire direct connection: Go to "Direct Wire Connection." 3-wire direct connection: Go to "Direct Wire Connection." NOTE: If local codes do not permit connection of a cabinet-ground conductor to neutral wire, go to "Optional External Ground 3-wire connection." This connection may be used with either a power supply cord or a direct wire connection. 2. Remove terminal block cover Using a wrench and tape measure, screw leveling legs into leg holes until bottom of foot is approximately 1/2" (13 mm) from bottom of dryer. Now stand the dryer on its feet. Slide the dryer until it is close to its final location. Remove hold-down screw and terminal block cover. 8