Xerox M118i System Administration Guide - Page 40
UNIX TCP/IP Environments, UNIX TCP/IP Installation, Installation Procedure
![]() |
UPC - 095205219265
View all Xerox M118i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
4 UNIX TCP/IP If you encounter problems during the installation of the machine, refer to Problem Solving chapter for assistance. CAUTION: Do not connect the network cable to the machine until instructed to do so. UNIX TCP/IP Environments System configuration The machine uses the Line Printer Daemon Protocol (LPD) that supports TCP/IP as the transport protocol. With the LPD, use the machine as a UNIX network printer. The LPD supports spool mode, this is where print jobs from clients are spooled once before output. It also supports non-spool mode, this is where print jobs are output sequentially, without spooling. Target computers The target computers are as follows. • Workstation or personal computer with RFC 1179 Line Printer Daemon Protocol Interface The LPD is available on the following interfaces: • Ethernet 100Base-TX • Ethernet 10Base-T The applicable frame types conform to Ethernet II (Ethernet interface). UNIX TCP/IP Installation This section explains how to install the machine in a UNIX TCP/IP environment. Installation Procedure There are three stages. Network Communication Setup This requires the machine to be set up and configured for TCP/IP. Workstation Setup This requires the appropriate workstation OS to be configured for the machine. 40 Xerox CopyCentre/WorkCentre 118 System Administration Guide
![](/manual_guide/products/xerox-m118-administration-guide-d725f36/40.png)