Xerox P8EX DocuColor 8000/7000 System Adminstration Guide - Page 80

1. To o ls M od e 28. Repeat Steps 11 through 19, then skip to Step 28a. a. If the curl is eliminated in both stacks of the output, continue printing the job. b. If the curl is eliminated in one stack but not the other, additional adjustments are required; proceed to Step 29. 29. To reduce the remaining paper curl, fine tune the E Table Settings by performing Steps 2-8 (in Step 4 select the same Paper Type E1 through E6 as used previously), then Step 29a a. If the 10 mm, 6 mm, and 2 mm values are 100%, reduce the 2 mm value to 50%. b. Do not change the other values. In this example, the Upper 10 mm and Upper 6 mm values are set to 100%. The Upper 2 mm value is set to 50%. The remaining values are set at 0% KEY POINT: The above illustration is an example only. Your actual E Table Settings for your print job may use different Upper/ Lower values than is shown above. c. Repeat Steps 11 through 19, then skip to Step 28d. d. If required, change these values: 2 mm = 25% 6 mm = 50% e. Repeat Steps 11 through 19, then skip to Step 30. 30. If you are not successful in reducing the curl, call your Xerox service representative. 1-56 DocuColor 8000/7000 System Administration Guide