Yamaha CLP-120 Owner's Manual - Page 40

ENGLISH About Each Function F1. Fine Tuning of the Pitch You can fine tune the pitch of the entire instrument. This function is useful when you play the Clavinova along with other instruments or CD music. 1. Engage Function mode and select . 2. Use the [-/NO] and [+/YES] buttons to lower or raise the pitch of the A3 key in approximately 0.2 Hz increments. ..... ..... Tenths of a hertz are indicated on the LED display by the appearance and position of one or two dots, as in the following example: Display Value 440.0 440.2 440.4 440.6 440.8 Setting range: 427.0-453.0 (Hz) Normal setting: 440.0 (Hz) TERMINOLOGY Hz (Hertz): This unit of measurement refers to the frequency of a sound and represents the number of times a sound wave vibrates in a second. TIP You can also use the keyboard to set the pitch (in any mode other than Function mode). To tune up (in about 0.2Hz steps): Hold the A-1 and B-1 keys (two white keys at the left end) simultaneously and press any key between C3 and B3. To tune down (in about 0.2Hz steps): Hold the A-1 and A 1 keys (a white and a black key at the left end) simultaneously and press any key between C3 and B3. To restore standard pitch: Hold the A-1, A -1 and B-1 (two white keys and one black key at the left end) simultaneously and press any key between C3 and B3. • Refer to "Part Names" on page 14 for information on the key and key name assignment. (During the procedure described above, the display indicates a value in Hz < ... >. After the procedure, the display returns to the previous indication.) TIP You can also tune in about 1Hz steps (in any mode other than Function mode). To tune down or up, respectively, in approximately 1 Hz increments: Hold the A-1 and A -1 keys (a white and a black key at the left end) or A-1 and B-1 keys (two white keys at the left end) simultaneously and press the [-/NO] or [+/YES] button. To restore standard pitch: Hold the A-1 and A -1 keys (a white and a black key at the left end) or A-1 and B-1 keys (two white keys at the left end) simultaneously and press the [-/NO] [+/YES] buttons simultaneously. (During the procedure described above, the display indi- cates a value in Hz < ... >. After the procedure, the display returns to the previous indication.) 40 CLP-130/120 Detailed Settings - [FUNCTION]