Yamaha CLP-120 Owner's Manual - Page 45

ENGLISH F.6 (CLP-130) / F.5 (CLP-120) Metronome Volume You can change the volume of the metronome sound. Use this function to adjust the metronome volume. 1. Engage Function mode and select 130)/ (CLP-120). (CLP- 2. Use the [-/NO] and [+/YES] buttons to set the metronome volume as required. Setting range: 1 - 20 Normal setting: 10 TIP SHORTCUT: You can jump directly to the metronome functions (CLP-130)/ (CLP-120) by pressing the [TEMPO/FUNC- TION#] button while holding the METRONOME [START/ STOP] button. To exit Function mode, you still need to press the [TEMPO/ FUNCTION#] button so that the TEMPO indicator lights up. F7. (CLP-130) / F6. (CLP-120) Preset Song Part Cancel Volume This function sets the volume at which a "canceled" part is played during preset song playback. Adjust the part volume to a comfortable level and use the "canceled" part as a guide with which to play along. 1. Engage Function mode and select 130)/ (CLP-120). (CLP- 2. Use the [-/NO] and [+/YES] buttons to set the volume as required. Setting range: 0 - 20 Normal setting: 5 F8. (CLP-130) / F7. (CLP-120) MIDI Functions You can make detailed adjustments to MIDI settings. For more information about MIDI, see the "About MIDI" section (page 49). TIP The HOST SELECT switch on the bottom surface must be set to "MIDI" to enable the MIDI connectors. When you use the TO HOST connector, set the HOST SELECT switch to the appropriate position for the type of computer you are using (pages 49-55). In this situation, all MIDI settings described below will affect the MIDI signal in and out of the TO HOST connector. 1. Engage Function mode and select 130)/ (CLP-120). (CLP- 2. Press the [+/YES] button to engage the MIDI function's sub-mode, then use the [TEMPO/ FUNCTION# M, L] buttons to select the desired sub-mode. Press the [-/NO] or [+/YES] button to set a selected parameter. Sub-mode F8.1: (CLP-130)/F7.1: (CLP-120) MIDI Transmit Channel Selection In any MIDI control setup, the MIDI channels of the transmitting and receiving equipment must be matched for proper data transfer. This parameter enables you to specify the channel on which the Clavinova transmits MIDI data. Setting range: 1 - 16, OFF (not transmitted) Normal setting: 1 NOTE In Dual mode, Voice 1 data is transmitted on its specified channel. In Split mode (CLP-130), right voice data is transmitted on its specified channel. In Dual mode, Voice 2 data is transmitted on the next greater channel number relative to the specified channel. In Split mode (CLP-130), left voice data is transmitted on the next greater channel number relative to the specified channel. In either mode, no data is transmitted if the transmit channel is set to "OFF". NOTE Demo/preset song data and recorder playback data are not transmitted via MIDI. CLP-130/120 Detailed Settings - [FUNCTION] 45