Yamaha CLP-265GP Owner's Manual - Page 44

ENGLISH Detailed Settings - [FUNCTION] F7.4: Program Change ON/OFF Normally the CLP-265GP will respond to MIDI program change numbers received from an external keyboard or other MIDI device, causing the correspondingly-numbered voice to be selected on the corresponding channel (the keyboard voice does not change). The CLP-265GP will normally also send a MIDI program change number whenever one of its voices is selected, causing the correspondingly-numbered voice or program to be selected on the external MIDI device if the device is set up to receive and respond to MIDI program change numbers. This function makes it possible to cancel program change number reception and transmission so that voices can be selected on the CLP-265GP without affecting the external MIDI device. NOTE For information on program change numbers for each of the CLP-265GP's voices, refer to page 62 in the MIDI Data Format section. Setting range: ON/OFF Normal setting: ON F7.5: Control Change ON/OFF Normally the CLP-265GP will respond to MIDI control change data received from an external MIDI device or keyboard, causing the voice on the corresponding channel to be affected by pedal and other "control" settings received from the controlling device (the keyboard voice is not affected). The CLP-265GP also transmits MIDI control change information when the pedal or other appropriate controls are operated. This function makes it possible to cancel control change data reception and transmission so that, for example, the CLP-265GP's pedal and other controls can be operated without affecting an external MIDI device. NOTE For information on control changes that can be used with the CLP-265GP, refer to the MIDI Data Format on page 61. Setting range: ON/OFF Normal setting: ON F7.: Panel/Status Transmit This function causes all the current CLP-265GP panel settings (selected voice, etc.) to be transmitted via the MIDI OUT terminal. TERMINOLOGY Setup Data: Data that contains a set of panel settings for the Clavinova. Procedure 1. Set up the panel controls as desired. 2. Connect the Clavinova to a sequencer via MIDI, and set up the sequencer so it can receive the setup data. 3. Engage the Function mode and select . 4. Press the [+/YES] button to transmit the panel/status data. will appear on the LED display when the data has been successfully transmitted. NOTE See page 62 for a list of the "Panel Data Contents" transmitted by this function. NOTE Receiving the transmitted data: 1. Connect the Clavinova via MIDI to the device to which the setup data was transmitted previously. 2. Start sending the setup data from the device. The Clavinova automatically receives the setup data, which will be reflected in the panel settings. (For the data to be accepted, the Clavinova that receives the setup data should be the same model as the one that transmitted the setup data to the sequencer.) NOTE For more information on transmitting and receiving setup data via MIDI, refer to the owner's manual for the connected MIDI device. F7.7: Initial Setup Send This function lets you send the data of the panel settings to a computer. By transmitting the panel settings and recording them on the MIDI sequence recorder prior to the actual performance data, the instrument will be automatically restored to the same settings when the performance is played back. You can also use this function to change the settings of a connected tone generator to the same settings as the instrument. Procedure 1. Set up the panel controls as desired. 2. Connect the Clavinova to a sequencer via MIDI, and set up the sequencer so it can receive the setup data. 3. Engage the Function mode and select . 4. Press the [+/YES] button to transmit the panel/status data. will appear on the LED display when the data has been successfully transmitted. The following data can be sent. • Voice selection • [REVERB] type • [REVERB] depth • [EFFECT] type • [EFFECT] depth • Tuning (F1) • Dual detune (F3.2) 44 CLP-265GP Owner's Manual