Yamaha CLP-265GP Owner's Manual - Page 48
Connecting a Personal Computer
View all Yamaha CLP-265GP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
ENGLISH Connections Connecting a Personal Computer By connecting a computer to the Clavinova's USB [TO HOST] terminal, you can transfer data between the instrument and the computer via MIDI. To do this, install the USB MIDI driver and Musicsoft Downloader software from the included CD-ROM. CAUTION When connecting the Clavinova to a personal computer, first turn off the power to both the Clavinova and the computer before connecting any cables. After making connections, turn on the power to the computer first, then to the Clavinova. CAUTION If you are not using the connection between the Clavinova and your computer, you must disconnect the cable from the USB [TO HOST] terminal. The Clavinova may not operate correctly if a cable is left connected. TERMINOLOGY Driver: A driver is software that provides a data-transfer interface between the computer's operating system and a connected hardware device. You need to install a USB MIDI driver to connect the computer and the instrument. Use a USB cable to connect the USB port on your computer to the USB [TO HOST] terminal on the Clavinova. Instrument USB [TO HOST] terminal USB cable Computer NOTE • The instrument will begin transmission a short time after the USB connection is made. • When using a USB cable to connect the instrument to your computer, make the connection directly without passing through a USB hub. • For information on setting up your sequence software, refer to the owner's manual of the relevant software. Precautions when using the USB [TO HOST] terminal When connecting the computer to the USB [TO HOST] terminal, make sure to observe the following points. Failing to do so risks freezing the computer and corrupting or even losing the data. If the computer or the instrument freezes, turn the power to the instrument off or restart the computer. CAUTION • Before connecting the computer to the USB [TO HOST] terminal, exit from any power-saving mode (such as suspended, sleep, standby) of the computer. • Before turning on the power to the instrument, connect the computer to the USB [TO HOST] terminal. • Execute the following before turning the power to the instrument on/off or plugging/ unplugging the USB cable to/from the USB [TO HOST] terminal. - Quit any open applications (such as Voice Editor, Multi Part Editor, and sequencer software). - Make sure that data is not being transmitted from the instrument. (Data is transmitted only by playing notes on the keyboard or playing back a song.) • While a USB device is connected to the instrument, you should wait for six seconds or more between these operations: (1) when turning the power of the instrument off then on again, or (2) when alternately connecting/disconnecting the USB cable. 48 CLP-265GP Owner's Manual