Yamaha CLP-265GP Owner's Manual - Page 52

ENGLISH Keyboard Stand Assembly Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please assemble in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can damage the stand. • Be sure to tighten all screws upon completing the assembly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver ready. 1. Remove all parts from the box. Confirm that all parts shown in the illustration are included. Main unit Lean the unit against the wall as shown at right. Legs Pedal box 6 × 40 mm fixing screws × 12 How to position the main unit CAUTION • Be careful not to pinch your fingers. Be sure to position the keyboard side on the bottom. Spread a large soft cloth, such as a blanket, on the floor. Place the unit on the cloth with the key cover closed and the keyboard side on the bottom and lean the unit against the wall so that the unit will not fall or slip. Place a soft cloth against the wall to protect the instrument and the wall from scratches. CAUTION • Do not place the main unit with the rear side facing down. CAUTION • Do not lay the main unit upside down on the floor. CAUTION • Do not position the main unit so that its bottom is in contact with floor. AC power cord Cord holder 6 × 20 mm fixing screws × 4 52 CLP-265GP Owner's Manual