Yamaha DG-Stomp Owner's Manual - Page 10

Connections Before making any connections to any of the DG-Stomp's INPUT and/or OUTPUT jacks, make sure that the power on the DG-Stomp and all other devices is turned OFF to prevent electrical shock or damage to the devices. s Connecting the Power Use the supplied power adaptor (AC-10) to supply power to the DG-Stomp. 1. Make sure the DG-Stomp's Power Switch (STAND-BY) is in the OFF ( ) position. 2. Connect the power adaptor's plug to the AC IN jack on the DG-Stomp. 3. Connect the power adaptor to an electric outlet. OFF ( ) s Connecting an Amp and Speaker System To setup with your guitar amp system, connect the OUTPUT jack on the DG-Stomp to a power amp and speaker. 1. Use a cable to connect the OUTPUT (R, L/ MONO) jack(s) on the rear panel of the DGStomp to the INPUT jack of a power amp. * We recommend the use of a stereo audio device to enjoy the full benefits of the stereo effects. 2. Connect a speaker to the speaker jack on the power amp. * Make sure that the speaker connected to the power amp is a compatible device (capacity, system impedance). Electrical Outlet Supplied AC Adaptor AC-10 Only use the supplied AC-10 adaptor to power the unit. Using another adaptor may result in damage, overheating or fire, which can be very dangerous. q You can connect the DG-Stomp to a guitar amp. * If the guitar amp is equipped with an effects loop, we recommend that the DG-Stomp be connected directly to the amplifier's EFFECT RETURN jack. If the amplifier is not equipped with an effects loop, connect to its INPUT jack and adjust the tone and volume on the guitar amp as required. * When connecting to monaural input devices, use the DGStomp's L/MONO jack. Make sure to use the recommended AC voltage as indicated on the power adaptor. The supplied power adaptor AC-10 is de- signed specifically for use with the DG- Stomp. Never use this adaptor with any other device. q You can also connect to the input jack 10 on a mixer, etc.