Yamaha DG-Stomp Owner's Manual - Page 16
Using the Foot Switch and the Bank, Switch, Using MIDI Control - owners manual
View all Yamaha DG-Stomp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Using the DG-Stomp q Using the Foot Switch and the Bank Switch • Press a foot switch (1-3) to select the corresponding patch number 1-3 in the currently selected group/bank. * If the Foot Switch's function is set to "EFF" in the Utility mode, it will not be possible to select a patch using the Foot Switch. (See page 23) • Press and hold the BANK switch until the display and the foot switch lamp flashes then remove your foot. In this condition, the following procedure can be used. * Even if the Foot Switch function is set to "EFF" in the Utility Mode, this mode can be entered by stepping on the BANK switch. 1. Hold Foot Switch 1 for more than one second to switch between the USER AREA ↔ PRESET AREA. When the area is changed, the Foot Switch's lamps will flash. 2. Hold Foot Switch 2 for more than one second to decrease the group number by a value of one. When the Group number is changed, the Foot Switch's lamps will flash. 3. Hold Foot Switch 3 for more than one second to increase the group number by a value of one. When the Group number is changed, the Foot Switch's lamps will flash. 4. Press a Foot Switch (1-3) to select the corresponding bank number (1-3). 5. When a BANK is selected, the lamp in the display and foot switch lamp will flash quickly. Press a Foot Switch (1-3) at this time to select the corresponding patch number (1-3). * To cancel the selected patch, press the BANK switch. It will return to the previous condition. q Using MIDI Control MIDI program change data transmitted from an external MIDI device such as the YAMAHA MIDI Foot Controller MFC10, etc. can be used to select patches in the DG-Stomp. 1. Use a MIDI cable to connect the MIDI IN jack on the DG-Stomp to the MIDI OUT jack on an external MIDI device. * Make sure to use a MIDI cable that conforms to the MIDI standard. Also, limit the length of the MIDI cable to 15 meters. Use of a long cable may result in trouble such as inferior performance of the device, etc. MIDI IN MIDI OUT MFC10, etc 2. Match the DG-Stomp's MIDI receive channel with the MIDI transmit channel on the external MIDI device. → page 24 [Set the MIDI Receive Channel] 3. Create a Program Change Table*. (Factory default → Program Change No : Patch No. = 1:011, 2:012...128:4.12) → page 24 [Create a Program Change Table] * This operation is used to assign patch numbers to a corresponding program change number received from an external device. For example, when the program change number "1" is received, the DG-Stomp's patch number "113" is recalled. 4. When program change data is transmitted from an external MIDI device, the patch is selected that corresponds to the program change table you created. * Refer to the owner's manual for your external MIDI device for instructions on how to transmit program change data. 16