Yamaha DG-Stomp Owner's Manual - Page 25
Set the External Control Number, Set the Parameter's Minimum Value
View all Yamaha DG-Stomp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Utility Mode To send a single USER AREA patch (data) with the Bulk Out operation. After pressing the [SPRING] button, select the patch number you want to send with the bulk out. Just as in selecting a patch number in the Play Mode, use the [UP]/[DOWN] buttons or the foot switches to select the patch. After selecting a patch, press the [STORE] button to carry out the MIDI Bulk Out operation with a single patch. * After transmitting the data the device will return to the previous condition, ready to select another patch number. q About the MIDI Bulk In This operation is used to return data stored in an external MIDI device such as the YAMAHA MDF3, etc., to the DG-Stomp. Use a MIDI cable to connect the MIDI OUT jack on the external MIDI device to the DG-Stomp's MIDI IN jack. When Bulk Out data is sent from the external device, the DG-Stomp will receive the bulk data. * Use the DG-Stomp's Play Mode to receive MIDI Bulk In data. When the MIDI Bulk In is carried out, the contents of the patches in the USER AREA will be rewritten. Please make sure any important data is saved before carrying out the MIDI Bulk In operation. s External Control Settings Just as in the [External Control Settings] section on page 21, these settings are used to control the DGStomp's volume, tone and effect parameters from a foot controller that is connected to the EXP. PEDAL jack or a MIDI device that is connected to the MIDI In jack. Press the [UTILITY] button then set the Amp Select switch to DRIVE1 ("CtL" will appear on the dis- play). q External Control's Operating Mode Setting Press the [COMP] button and use the [UP]/[DOWN] buttons to select an Operating Mode for the external control. • GLb : The external control setting in the Utility Mode is always available. • PrG : The external control setting that is set in the patch is available. • oFF : The external control is always OFF. q Set the External Control Number Press the [CHORUS] button and use the [UP]/ [DOWN] buttons to set a control number (1-8). * Refer to [External Control Settings] (page 21) q Set the External Controller Press the [FLANGER] button and use the [UP]/ [DOWN] buttons to select the type of controller (EP, 1-31, 64-95). * Refer to [External Control Settings] (page 21) q Set the Parameter to be Controlled Press the [PHASER] button and use the [UP]/ [DOWN] buttons to select the parameter to be con- trolled (UUH-). * Refer to [External Control Settings] (page 21) q Set the Parameter's Minimum Value Press the [ROTARY] button and use the [UP]/ [DOWN] buttons to set the parameter's minimum value (the parameter's value when the controller is set to its minimum: 0.0-10.0). * Refer to [External Control Settings] (page 21) q Set the Parameter's Maximum Value Press the [TREMOLO] button and use the [UP]/ [DOWN] buttons to set the parameter's maximum value (the parameter's value when the controller is set to its maximum: 0.0-10.0). * Refer to [External Control Settings] (page 21) 25