Yamaha DG-Stomp Owner's Manual - Page 27
Wah Pedal Settings, The Speaker Simulator, Preamp Circuit ON/OFF Settings
View all Yamaha DG-Stomp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Utility Mode s Wah Pedal Settings These settings are available when the Wah Pedal function ("UUH") is selected as the controller in the External Control settings. Press the [UTILITY] button then set the amp select switch to CRUNCH1 ("UUH" will appear on the dis- play). q Set the Low Frequency of the Wah Pedal Sets the low frequency in the wah pedal's frequency range. Press the [COMP] button and use the [UP]/[DOWN] buttons to set the frequency (150-500:Hz). s Preamp Circuit ON/OFF Settings When the DG-Stomp's preamp circuit is not used, it is possible to use the DG-Stomp as an effector or a MIDI foot controller. Press the [UTILITY] button then set the amp select switch to CLEAN1. Use the [UP]/[DOWN] buttons to set the preamp circuit ON/OFF. • on : The preamp circuit is active (in use) • oFF : The preamp circuit is inactive (not in use) q Set the High Frequency of the Wah Pedal Sets the high frequency in the wah pedal's frequency range. Press the [CHORUS] button and use the [UP]/ [DOWN] buttons to set the frequency (1.505.00:kHz). q Set the Wah Pedal "Q" Sets the frequency curve of the wah pedal. Press the [FLANGER] button and use the [UP]/ [DOWN] buttons to select a curve (1.00-5.00). s The Speaker Simulator Press the [UTILITY] button then set the amp select switch to CRUNCH2. The current setting will appear on the display. Use the [UP]/[DOWN] buttons to select a speaker simulator mode. • GLb : The speaker simulator is always ON. • PrG : The speaker simulator is switched ON/ OFF according to the patch setting. • oFF : The speaker simulator is always OFF 27