Yamaha DSP-A1 Owner's Manual - Page 22
IMPEDANCE SELECTOR switch
View all Yamaha DSP-A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Ⅵ IMPEDANCE SELECTOR switch Be sure to switch this only when the power to this unit is not on. Select the position whose requirements your speaker system meets. WARNING Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged. IF THIS UNIT FAILS TO TURN ON WHEN THE STANDBY/ON SWITCH IS PRESSED; The IMPEDANCE SELECTOR switch may not be set to either end closely. If so, set the switch to either end closely. IMPEDANCE SELECTOR (Left position) Rear: The impedance of each speaker must be 4Ω or higher. Center: If you use two center speakers, the impedance of each speaker must be 4Ω or higher. If you use one center speaker, the impedance of the speaker must be 4Ω or higher. Main: The impedance of each speaker must be 4Ω or higher. Front effect: The impedance of each speaker must be 6Ω or higher. A+ B A OR B IMPEDANCE SELECTOR SET BEFORE POWER ON MAIN : 4ΩMIN. /SPEAKER CENTER A B : 4ΩMIN. /SPEAKER A OR B : 4ΩMIN. /SPEAKER REAR : 4ΩMIN. /SPEAKER FRONT EFFECT : 6ΩMIN. /SPEAKER MAIN : 8ΩMIN. /SPEAKER CENTER A B : 4ΩMIN. /SPEAKER A OR B : 8ΩMIN. /SPEAKER REAR : 8ΩMIN. /SPEAKER FRONT EFFECT : 8ΩMIN. /SPEAKER FRONT REAR (SURROUND) VOLTAGE SELECTOR AC OUTLETS SWITCHED UNSWITCHED I00W MAX. TOTAL 200W MAX. (Right position) Rear: The impedance of each speaker must be 8Ω or higher. Center: If you use two center speakers, the impedance of each speaker must be 4Ω or higher. If you use one center speaker, the impedance of the speaker must be 8Ω or higher. Main: The impedance of each speaker must be 8Ω or higher. Front effect: The impedance of each speaker must be 8Ω or higher. (General model) 20