Yamaha EMX5014C Owner's Manual - Page 24
Master REC OUT Jacks, EFF ON/OFF Jack, PHONES Jack, POWER Indicator, Graphic Equalizer
UPC - 086792838274
View all Yamaha EMX5014C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Reference Front & Rear Panels Master Section R X Y Z \ ] P REC OUT Jacks These RCA pin-type unbalanced output jacks can be used to send the main stereo signal to an external DAT P recorder or cassette recorder. The jacks output the ste- reo signal pre adjustment by the ST master fader g Q and graphic equalizer V. As the signal is not adjusted by these controls, please be sure to make appropriate level adjustments at the external recording device side. S T Q EFF ON/OFF Jack This phone input jack is for connection to a separately sold FC5 foot switch. The foot switch can be used as an alternative to the ON switch to toggle the effector on and off. R ST SUB OUT Jacks These unbalanced phone jacks output the mixed stereo signal (L and R), where the level is adjusted by the U Master Control section's ST SUB OUT c control. You would typically use these jacks to connect to an exter- nal mixer or a supplementary SR system. V S ST OUT Jacks These unbalanced phone jacks output the mixed stereo signal (L and R), where the level is adjusted by the ST W master fader g. You would typically connect these [ jacks to a power amp or powered speakers. T PHONES Jack Connector for headphones. This is a balanced stereo phone-type output jack. ` U POWER Indicator The indicator lights up when the POWER switch i is a on. b V Graphic Equalizer This 9-band graphic equalizer adjusts the frequency c characteristics of the stereo-bus signal output at the ST OUT jacks S, ST SUB OUT jacks R, and SPEAK- ERS jacks h. Each band can be adjusted by ±12 dB. The base frequencies for the bands are: 63, 125, 250, 500, 1k, 2k, 4k, 8k and 16k Hz. W GEQ ON Switch This switch toggles the graphic equalizer on or off. The switch is illuminated when on. X LIMITER Indicator The lamp lights up when the amplified signal output at the SPEAKERS jacks hits its maximum value. The lamp indicates that the limiter has come on. If the lamps are flashing frequently, the load on the amp is too high and there is risk of damage to your equipment. Reduce the setting of the ST master fader g or the AUX1 or AUX2 fader f until the lamps flash only briefly or not at all. 24 EMX5014C Owner's Manual