Yamaha EMX66M Owner's Manual - Page 11
Front and rear panel, Control panel - amp
View all Yamaha EMX66M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Front and rear panel 9 Front and rear panel Control panel s Channel section In this section, you can adjust equalization (frequency response), volume level, effect and monitor output levels for the input signal of each channel. 1 HIGH 1 -15 +15 MID -15 +15 LOW 2 3 4 -15 +15 MONITOR 0 +15 EFFECT 0 +15 LEVEL 0 10 PAD 5 1 1 Equalizer controls (HIGH, MID, LOW) This is a 3-band equalizer that adjusts the high frequency range, mid frequency range, and low frequency range of each channel. Response is flat when the knobs are in the "w" position. Rotating it toward the right will boost the corresponding frequency band, and rotating it toward the left will cut it. The base frequency (or center frequency), range of boost or cut, and equalizer type of each band are as follows. HIGH: 10 kHz ±15 dB shelving type MID: 2.5 kHz ±15 dB peaking type LOW: 100 Hz ±15 dB shelving type 2 Monitor control (MONITOR) For each channel, this controls the amount of signal that is sent to the MONITOR bus. The signal of the MONITOR bus is sent to the speakers connected to the SPEAKERS B 1/2 jacks (only if the power amp select switch is in the MAIN-MON position) and to the MONITOR jacks (input/output panel 6). Note: The signal is sent to the MONITOR bus from a location before the level control (4) of each channel. This means that it will not be affected by the setting of the LEVEL control. 3 Effect control (EFFECT) For each channel, this controls the amount of signal that is sent to the EFFECT bus. The signal of the EFFECT bus is sent to the builtin effect and to the EFFECT OUT jacks (input/ output panel 3). Note: The signal is sent to the EFFECT bus from a location after the level control (4) of each channel. This means that the amount of signal that is sent to the EFFECT bus will be affected not only by the setting of the effect control, but also by the setting of the level control. 4 Level control (LEVEL) This control adjusts the level of signals routed from each channel to the MAIN bus and to the built-in power amplifier. The MAIN bus signal is sent to the MAIN jacks (input/output panel 6) and the SPEAKERS jacks on the rear panel 1. 5 Pad switch (PAD) (Channel 1-4 only) This switch attenuates the input signal by 30 dB. When connecting a line level device to channels 1-4, or if the mic input is distorted, turn this switch on (the pressed-in position). EMX66M-Owner's Manual