Zanussi ZOD35802BK User Manual - Page 20
Removing And Installing The Door, Warning, Caution, Replacing The Lamp, The Back Lamp
![]() |
View all Zanussi ZOD35802BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
• clean the oven floor with warm water and mild detergent. • clean the inner door glass with warm water and soft cloth. 1. Set the function . 2. Set the oven temperature to 250 °C and let the oven operate for 1 hour. 3. Turn off the oven. 4. When the oven cools down, clean the cavity with a wet soft cloth. Spots or discolouration of the catalytic coating have no effect on Catalytic cleaning. REMOVING AND INSTALLING THE DOOR You can remove the door and the internal glass panels to clean it. The number of glass panels is different for different models. WARNING! The door is heavy. 6. Hold the door trim (B) on the top edge of the door at the two sides and push inwards to release the clip seal. 2 B 1 CAUTION! Rough handling of the glass, especially around the edges of the front panel, can cause the glass to break. 7. Pull the door trim to the front to remove it. 8. Hold the door glass panels on their top edge one by one and pull them up out of the guide. 1. Open the door fully. 2. Fully lift up the clamping levers (A) on the two door hinges. A A 3. Close the door until it is at an angle of approximately 45°. 45° 4. Hold the door with one hand on each side and pull it away from the oven at an upwards angle. 5. Put the door with the outer side down on a soft cloth on a stable surface. 9. Clean the glass panel with water and soap. Dry the glass panel carefully. When the cleaning is completed, do the above steps in the opposite sequence. Install the smaller panel first, then the larger and the door. WARNING! Make sure that the glasses are inserted in the correct position otherwise the surface of the door may overheat. REPLACING THE LAMP WARNING! Risk of electric shock. The lamp can be hot. 1. Turn off the oven. Wait until the oven is cooled down. 2. Disconnect the oven from the mains. 3. Put a cloth on the bottom of the cavity. The back lamp The lamp glass cover is at the back of the cavity. 20
![](/manual_guide/products/zanussi-zod35802bk-user-manual-dbe14b3/20.png)