Zenith C27F33 Operating Guide - Page 9
Channel Search
View all Zenith C27F33 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Channel Search Channel Search memorizes all the active channels in your area. You must do a channel search before you can use the TV. There are two ways of memorizing channels. You can use either. One is AUTO PROGRAM and the other is MANUAL PROGRAM. In AUTO PROGRAM, the TV memorizes the channels in ascending numerical order. If there are additional channels you want to add or delete, add or delete them manually. Memorizing the Channels with AUTO PROGRAM AUTO PROGRAM searches and memorizes all the active channels in your area then you can select the desired channel with the D / E buttons. Using the a.prog Button AUTO PROGRAM the TV using the convenient a.prog button on the remote control. 1. Press the a.prog button. 2. Use the D/ E button to select Normal or Turbo. 3. Press the G or a.prog button to start AUTO PROGRAM. The AUTO PROGRAM starts now. If you want to stop auto programming, press the enter (A) button. Only the channels searched up to that time will be memorized. Turbo auto program works faster than Normal auto program. Notes • If broadcast signals are poor quality, try memorize channels again using Normal auto program. • AUTO PROGRAM stores all available channels regardless of signal (RF, Cable). • If over-the-air and Cable TV channels are duplicated, use the number buttons (0 ~ 9) to change as Channels of general wireless TV Channels of Cable TV . Using the Auto Program Menu 1. Press the menu button and use D / E button to select the menu shown to the right. 2. Press the G and then use D/ E button to select Auto program. 3. Press the G button to enter the Auto program mode. 4. Use the D / E button to select Normal auto program or Turbo auto program. 5. Press the G button button to start AUTO PROGRAM. The AUTO PROGRAM starts now. +Auto+program++Normal Auto+program TV15 10% Å:STOP Auto+program Manual+program Favorite+channel ++MOVE+{NEXT+MENU:EXIT NNoorrmmaall++aauuttoo++pprrooggrraamm Turbo+auto+program ++MOVE+{NEXT+}BACK 9