Zenith C34W23 Operating Guide - Page 8

Hook Up an Off-Air Antenna Connect an off-air antenna 1 Locate the Antenna/Cable 1 jack on the back of your TV. 2 Connect the antenna wire that runs from the wall directly to this jack, according to one of the diagrams to the right. 3 Remove the back of the remote and put in two "AAA" batteries. Antenna Back of Remote Flat Wire (300 ohm) 4 Plug in your TV. Your TV is designed to operate on standard household current, 120-volt 60 Hertz AC. Do not plug it into an outlet con- trolled by a switch. Do not attempt to operate it on DC power. 300/75 ohm Adapter 120 V AC 60 Hz Antenna If you have a 75 ohm RF cable, then you don't need any adapters! A 300 to 75 ohm adapter is not included with the TV. RF Coaxial Wire (75 ohm) Typical TV Back ANTENNA/ CABLE 1 Typical TV Back ANTENNA/ CABLE 1 Mini glossary 75 OHM RF CABLE 300 TO 75 OHM ADAPTER The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking through the middle, and it screws onto the threaded antenna/cable jack on the back of your TV. A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end. PAGE 8 206-3767