Zenith C34W23 Operating Guide - Page 9

Hook Up Cable Service (CATV) Connect cable service to your Entertainment Machine 1 Locate the Antenna/Cable jack on the back of the TV. 2 Connect the cable service wire that runs from the wall or cable box directly to this jack, according to one of the diagrams to the right. 3 Remove the back of the remote and put in two "AAA" batteries. Back of Remote 4 Plug in your TV. Your TV is designed to operate on standard household current, 120-volt 60 Hertz AC. Do not plug it into an outlet controlled by a switch. Do not attempt to operate it on DC power. 120 V AC 60 Hz If you're using a cable box, leave the TV on channel 3 or 4 and use your cable box to change channels. If you're using a cable box, EZ Scan might only find the channel your cable service is on (usually channel 3 or 4). Don't worry, that's all you need! Typical Cable TV Wall Jack Coaxial Round Wire (75 ohm) Typical TV Back ANTENNA/ CABLE 1 Typical Cable TV Wall Jack In Cable Box Out output switch 3 4 RF Coaxial Wire (75 ohm) Typical TV Back ANTENNA/ CABLE 1 206-3767 PAGE 9