ZyXEL VMG4381 User Guide - Page 82
Table 8, Label, Description
View all ZyXEL VMG4381 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Chapter 6 Broadband Table 8 Routing Mode (continued) LABEL Type DESCRIPTION Select whether it is ADSL/VDSL over PTM, ADSL over ATM, or Ethernet connection. Mode Encapsulation • ADSL/VDSL over PTM: The Device uses the VDSL technology for data transmission over the DSL port. • ADSL over ATM: The Device uses the ADSL technology for data transmission over the DSL port. • Ethernet: The Device transmits data over the Ethernet WAN port. Select this if you have a DSL router or modem in your network already. Select Routing if your ISP give you one IP address only and you want multiple computers to share an Internet account. Select the method of encapsulation used by your ISP from the drop-down list box. This option is available only when you select Routing in the Mode field. • PPP over Ethernet (PPPoE): PPPoE (Point to Point Protocol over Ethernet) provides access control and billing functionality in a manner similar to dial-up services using PPP. Select this if you have a username and password for Internet access. • IP over Ethernet (IPoE): In this type of Internet connection, IP packets are routed between the Ethernet interface and the WAN interface and then formatted so that they can be understood in a bridged environment. • PPP over ATM (PPPoA): PPPoA allows just one PPPoA connection over a PVC. • IP over ATM (IPoA): IPoA allows just one RFC 1483 routing connection over a PVC. If your connection type is ADSL/VDSL over PTM or Ethernet, the choices are PPPoE and IPoE. If your connection type is ADSL over ATM, the choices are PPPoE, PPPoA, IPoE and IPoA. IPv6/IPv4 Mode Select IPv4 Only if you want the Device to run IPv4 only. Select IPv6/IPv4 DualStack to allow the Device to run IPv4 and IPv6 at the same time. Select IPv6 Only if you want the Device to run IPv6 only. ATM PVC Configuration (These fields appear when the Type is set to ADSL over ATM.) VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you. VCI The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management of ATM traffic). Enter the VCI assigned to you. DSL Link Type This field is not editable. The selection depends on the setting in the Encapsulation field. EoA (Ethernet over ATM) uses an Ethernet header in the packet, so that you can have multiple services/connections over one PVC. You can set each connection to have its own MAC address or all connections share one MAC address but use different VLAN IDs for different services. EoA supports ENET ENCAP (IPoE), PPPoE and RFC1483/2684 bridging encapsulation methods. PPPoA (PPP over ATM) allows just one PPPoA connection over a PVC. IPoA (IP over ATM) allows just one RFC 1483 routing connection over a PVC. VMG4381-B10A User's Guide 82