ZyXEL XGS-4728F User Guide - Page 204

Chapter 20 Classifier Table 49 Advanced Application > Classifier (continued) LABEL DESCRIPTION Socket Number Note: You must select either UDP or TCP in the IP Protocol field before you configure the socket numbers. Add Cancel Clear Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option and enter a TCP/UDP protocol port number. Click Add to insert the entry in the summary table below and save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. Click Clear to set the above fields back to the factory defaults. 20.3 Viewing and Editing Classifier Configuration To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the Classifier screen. To change the settings of a rule, click a number in the Index field. Note: When two rules conflict with each other, a higher layer rule has priority over a lower layer rule. Figure 88 Advanced Application > Classifier: Summary Table The following table describes the labels in this screen. Table 50 Classifier: Summary Table LABEL DESCRIPTION Index This field displays the index number of the rule. Click an index number to edit the rule. Active This field displays Yes when the rule is activated and No when it is deactivated. Name This field displays the descriptive name for this rule. This is for identification purposes only. Rule This field displays a summary of the classifier rule's settings. 204 XGS-4526/4528F/4728F User's Guide