ZyXEL XGS-4728F User Guide - Page 427

Chapter 48 Syslog 48.3 Syslog Server Setup Click Management > Syslog > Syslog Server Setup to open the following screen. Use this screen to configure a list of external syslog servers. Figure 233 Management > Syslog > Server Setup The following table describes the labels in this screen. Table 160 Management > Syslog > Server Setup LABEL DESCRIPTION Active Select this check box to have the device send logs to this syslog server. Clear the check box if you want to create a syslog server entry but not have the device send logs to it (you can edit the entry later). Server Address Enter the IP address of the syslog server. Log Level Select the severity level(s) of the logs that you want the device to send to this syslog server. The lower the number, the more critical the logs are. Add Click Add to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non- volatile memory when you are done configuring. Cancel Click Cancel to begin configuring this screen afresh. Clear Click Clear to return the fields to the factory defaults. Index This is the index number of a syslog server entry. Click this number to edit the entry. Active This field displays Yes if the device is to send logs to the syslog server. No displays if the device is not to send logs to the syslog server. IP Address This field displays the IP address of the syslog server. Log Level This field displays the severity level of the logs that the device is to send to this syslog server. Delete Select an entry's Delete check box and click Delete to remove the entry. Cancel Click Cancel to begin configuring this screen afresh. XGS-4526/4528F/4728F User's Guide 427