ZyXEL XGS-4728F User Guide - Page 42
Uplink Module, Rear Panel Connections
View all ZyXEL XGS-4728F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Chapter 3 Hardware Overview Figure 17 Rear Panel - DC Model GF 3.2.3 Uplink Module The following figure shows the front panel of the EM-422 and EM-412 modules. Figure 18 The Front Panel of the EM-422 and EM-412 Modules EM-422 EM-412 3.2.4 Rear Panel Connections The following table describes the ports on the rear panel. Table 2 Panel Connections CONNECTO R DESCRIPTION Optional two XFP or CX4 Ports These ports are available when you install an EM-422 or ES-412 in the optional uplink module (B in the figure above). Both the EM-422 and ES412 are used to connect your switch to other high-speed Ethernet switches for stacking in you network. Two stacking ports • For EM-422 connection: Use 10 Gigabit Small Form Factor Pluggable (XFP) transceivers to connect 1000Base-X fiber-optic cables to these ports. See Section 3.1.3.1 on page 39 and Section 3.1.3.2 on page 40 for information on installing and removing transceivers. • For EM-412 connection: Use 10GBase-CX4 cables to connect to these ports. See the EM-422 and EM-412 User's Guides for more information. Connect these ports to other XGS-4528F or XGS-4728F switches for stacking using stacking cables. (XGS-4528F or XGS4728F) Management Port Console Port Connect to a computer using an RJ-45 Ethernet cable for local configuration of the Switch. Only connect this port to your computer (using an RS-232 cable) if you want to configure the Switch using the command line interface (CLI) via the console port. 42 XGS-4526/4528F/4728F User's Guide