ZyXEL XGS-4728F User Guide - Page 55
Reload the Configuration File
View all ZyXEL XGS-4728F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Chapter 4 The Web Configurator 4.6.1 Reload the Configuration File Uploading the factory-default configuration file replaces the current configuration file with the factory-default configuration file. This means that you will lose all previous configurations and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password will also be reset to "1234" and the IP address to 192.168.1.1. To upload the configuration file, do the following: 1 Connect to the console port using a computer with terminal emulation software. See Section 3.2 on page 41 for details. 2 Disconnect and reconnect the Switch's power to begin a session. When you reconnect the Switch's power, you will see the initial screen. 3 When you see the message "Press any key to enter Debug Mode within 3 seconds ..." press any key to enter debug mode. 4 Type atlc after the "Enter Debug Mode" message. 5 Wait for the "Starting XMODEM upload" message before activating XMODEM upload on your terminal. 6 After a configuration file upload, type atgo to restart the Switch. Figure 22 Resetting the Switch: Via the Console Port Bootbase Version: V1.00 | 10/22/2007 12:48:50 RAM:Size = 128 Mbytes DRAM POST: Testing:131072K OK DRAM Test SUCCESS ! FLASH: Intel 64M ZyNOS Version: V4.00(BBC.0)b1 | 10/14/2010 17:32:18 Press any key to enter debug mode within 3 seconds Enter Debug Mode ras> atlc Starting XMODEM upload (CRC mode).... CCCCCCCCCCCCCCCC Total 393216 bytes received. Erasing OK ras> atgo XGS-4526/4528F/4728F User's Guide 55