1993 Chevrolet Corvette Owner's Manual - Page 124

7. Fully tighten the rear bolts,then the 3 Lower the roof panel onto the top of . Reinstalling the Roof Panel: front bolts. If the balts-aren't tight first, placing the the vehicle, rear edge '1. Follow steps1-7 in Removing the enough, the roof panel may male a rear guide pinsof the roof panel into Roof Panel, earlier this .section,to popping noise wbde you drive. If this their locating holes. prepare your vehicle. 4 Lower the front of the roofpaneland I happens, tighten the bolts securely. . I 2. Open the rear hatch and remove the position the front guide pins. roof panel horn its stored position by reversing the procedure in Storing the 5. Use the wrench to partially tighten the two rear attachingbslts. Roof Panel, earlier in this section. I I V U I It€ I 6. Use the wrench to loosely start the front two attaching bolts, making sure the bolts are properly threaded into the roof panel.If the front bolts seem hard to start, tighten the rear bolts some more. Also, holding down the panel on the outsidewill help you start the bolts.