2006 Chevrolet SSR Pickup Owner's Manual - Page 41

1. Attach and tighten the lower attachments to the lower anchors. If the child restraint does not have lower attachments or the desired seating position does not have lower anchors, secure the child restraint with the top tether and the safety belts. Refer to your child restraint manufacturer instructions and the instructions in this manual. 1.1. Your vehicle has a passenger airbag. There is an airbag off switch in the glove box you can use to turn off the passenger's airbag. See Airbag Off Switch on page 1-48 for more on this, including important safety information. Never use a rear-facing child restraint in this seat unless the airbag is off. 1.2. Find the lower anchors for the desired seating position. 1.3. Put the child restraint on the seat. 1.4. Attach and tighten the lower attachments on the child restraint to the lower anchors. 2. If the child restraint manufacturer recommends that the top tether be attached, attach and tighten the top tether to the top tether anchor, if equipped. Refer to the child restraint instructions and the following steps: 2.1. Find the top tether anchor. You may have to move you seat forward to access the top tether anchor. See Power Seats on page 1-2. 2.2. Route, attach, and tighten the top tether according to your child restraint instructions and the following instructions: If the position you are using has a halo head restraint and you are using a single tether, route the tether through the hole in the head restraint. If the position you are using has a halo head restraint and you are using a dual tether, route the tether through the hole in the head restraint. 3. If your child restraint is forward-facing, always move the seat as far back as it will go. See Power Seats on page 1-2. 4. Push and pull the child restraint in different directions to be sure it is secure. 1-35