2015 Chrysler Town & Country Owner Manual - Page 272

270 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you wish to For programming transmitters in Canada/United States program while keeping the HomeLink® indicator that require the transmitter signals to "time-out" after light in view. several seconds of transmission. Canadian radio frequency laws require transmitter sig- 3. Continue to push and hold the HomeLink® button, while you push and release ("cycle") your hand-held nals to time-out (or quit) after several seconds of transtransmitter every two seconds until HomeLink® has mission - which may not be long enough for HomeLink® successfully accepted the frequency signal. The indito pick up the signal during programming. Similar to this cator light will flash slowly and then rapidly when Canadian law, some U.S. gate operators are designed to fully trained. time-out in the same manner. Canadian/Gate Operator Programming It may be helpful to unplug the device during the cycling 4. Watch for the HomeLink® indicator to change flash rates. When it changes, it is programmed. It may take process to prevent possible overheating of the garage up to 30 seconds or longer in rare cases. The garage door or gate motor. door may open and close while you are programming. 1. Cycle the ignition to the ON/RUN position. 5. Push and hold the programmed HomeLink® button and observe the indicator light.