2015 Chrysler Town & Country Owner Manual - Page 322

320 UNDERSTANDING YOUR INSTRUMENT PANEL 6. Odometer Display/Electronic Vehicle Information This also displays Trip A and Trip B, DTE, MPG or Center (EVIC) - If Equipped L/100km, OAT (Outside Air Temperature) information to Base Cluster, use STEP and RESET button (on steering Odometer Display / Trip Odometer Display The odomwheel) to access or reset the display. eter display shows the total distance the vehicle has been Message Display Area driven. U.S. Federal regulations require that upon transfer of vehicle ownership, the seller certify to the purchaser the correct mileage that the vehicle has been driven. If your odometer needs to be repaired or serviced, the repair technician should leave the odometer reading the same as it was before the repair or service. If s/he cannot do so, then the odometer must be set at zero, and a sticker must be placed in the door jamb stating what the mileage was before the repair or service. It is a good idea for you to make a record of the odometer reading before the repair/ service, so that you can be sure that it is properly reset, or that the door jamb sticker is accurate if the odometer must be reset at zero. When the appropriate conditions exist, the following odometer messages will display: door ...Door Ajar gATE ...Liftgate Ajar LoW tirE ...Low Tire Pressure gASCAP ...Fuel Cap Fault noFUSE ...Fuse Fault CHAngE OIL ...Oil Change Required LoCOOL ...Low Coolant NOTE: Some of the above warnings will be displayed in the Electronic Vehicle Information Center Display Area located in the instrument cluster.