2015 Chrysler Town & Country Owner Manual - Page 324

322 UNDERSTANDING YOUR INSTRUMENT PANEL 1. Turn the ignition switch to the ON/RUN position (do 7. Anti-Lock Brake (ABS) Light not start the engine). This light monitors the Anti-Lock Brake System 2. Fully push the accelerator pedal, slowly, three times (ABS). The light will turn on when the ignition within 10 seconds. switch is turned to the ON/RUN position and may stay on for as long as four seconds. 3. Turn the ignition switch to the OFF position. If the ABS light remains on or turns on while driving, it NOTE: If the indicator message illuminates when you indicates that the Anti-Lock portion of the brake system start the engine, the oil change indicator system did not is not functioning and that service is required. However, reset. If necessary, repeat these steps. the conventional brake system will continue to operate Electronic Vehicle Information Center (EVIC) - If normally if the BRAKE warning light is not on. Equipped If the ABS light is on, the brake system should be serviced The Electronic Vehicle Information Center (EVIC) fea- as soon as possible to restore the benefits of Anti-Lock tures a driver-interactive display that is located in the brakes. If the ABS light does not turn on when the instrument cluster. For further information, refer to ignition switch is turned to the ON/RUN position, have "Electronic Vehicle Information Center (EVIC)" in this the light inspected by an authorized dealer. section.