2015 Chrysler Town & Country Owner Manual - Page 473

STARTING AND OPERATING 471 Installing And Removing The ENGINE START/STOP Button Installing The Button 1. Remove the key fob from the ignition switch. NOTE: The ENGINE START/STOP button should only be removed or inserted with the ignition in the OFF position (OFF position for Keyless Enter-N-Go™). Normal Starting 2. Insert the ENGINE START/STOP button into the Using The ENGINE START/STOP Button ignition switch with the lettering facing up and read- 1. The transmission must be in PARK or NEUTRAL. able. 2. Press and hold the brake pedal while pushing the 3. Press firmly on the center of the button to secure it into ENGINE START/STOP button once. position. 3. The system takes over and attempts to start the Removing The Button vehicle. If the vehicle fails to start, the starter will disengage automatically after 10 seconds. 1. The ENGINE START/STOP button can be removed from the ignition switch for key fob use. 4. If you wish to stop the cranking of the engine prior to the engine starting, push the button again. 2. Insert the metal part of the emergency key under the chrome bezel at the 6 o'clock position and gently pry NOTE: Normal starting of either a cold or a warm engine the button loose. is obtained without pumping or pressing the accelerator pedal. 5