2012 Dodge Caliber Owner Manual - Page 19

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17 3. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON/RUN position within 15 seconds. After 10 seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash. Turn the ignition switch to the LOCK position and remove the second key. Repeat this procedure to program up to eight keys. If you do not have a programmed Sentry Key௡, contact your authorized dealer for details. NOTE: If a programmed key is lost, see your authorized dealer to have all remaining keys erased from the system's memory. This will prevent the lost key from 4. Insert a blank Sentry Key௡ into the ignition switch. starting your vehicle. The remaining keys must then be Turn the ignition switch to the ON/RUN position within reprogrammed. All vehicle keys must be taken to an 60 seconds. After 10 seconds, a single chime will sound. authorized dealer at the time of service to be In addition, the Vehicle Security Light will stop flashing. reprogrammed. To indicate that programming is complete, the Vehicle General Information Security Light will turn on again for three seconds and The Sentry Key௡ system complies with FCC rules Part 15 then turn off. and with RSS-210 of Industry Canada. Operation is The new Sentry Key௡ is programmed. The Remote subject to the following conditions: Keyless Entry (RKE) transmitter will also be pro- • This device may not cause harmful interference. grammed during this procedure. • This device must accept any interference that may be received, including interference that may cause undesired operation. 2