2012 Dodge Caliber Owner Manual - Page 452

450 MAINTAINING YOUR VEHICLE BULB REPLACEMENT Front Headlamps, Parking, and Turn Signal Lamps NOTE: The headlamp bulb can be accessed from under the hood without the removal of the inner fender well. It will be necessary to remove the inner fender well to service the park/turn signal bulb that is located toward the outboard side of the head lamp unit. 1. Disconnect and isolate the negative battery cable. 5. Grasp the bulb, twist 1/4 turn counterclockwise and pull straight out of front lamp unit. Fog Lamps CAUTION! Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result. 1. Disconnect and isolate the negative battery cable. 2. Working in the appropriate wheel well, loosen the 2. Remove the front wheel and tire on the same side of front of the splash shield, but do not fully remove it. the vehicle as the fog lamp being serviced. Refer to 3. Looking up through the front wheel well, locate the "Jacking and Tire Changing" in "What To Do In Emerbulb which needs replacing. The headlamp bulb is the gencies" for further information. inboard bulb and the park/turn signal bulb is the out3. Remove the three screws that secure the outboard side board bulb. of the front wheel house splash shield to the front fascia. 4. Disconnect the bulb electrical connector.