2012 Dodge Caliber Owner Manual - Page 210

208 UNDERSTANDING YOUR INSTRUMENT PANEL five seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure. 15. Cruise Indicator - If Equipped This indicator shows that the Speed Control system is ON. Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN 16. Trip/Odometer Display Reset Button position. To turn off the message temporarily, press and Press this button to change the display from odometer to release the Trip Odometer button on the instrument either of the two trip odometer settings. Trip A or Trip B cluster. To reset the oil change indicator system (after will appear when in the trip odometer mode. Push in and performing the scheduled maintenance), refer to the hold the button for two seconds to reset the trip odometer following procedure: to 0 miles (0 km). The odometer must be in Trip mode to 1. Turn the ignition switch to the ON/RUN position. reset. Do not start the engine. 17. Electronic Throttle Control (ETC) Light 2. Fully depress the accelerator pedal slowly three This light informs you of a problem with the times within 10 seconds. Electronic Throttle Control (ETC) system. If a problem is detected, the light will come on 3. Turn the ignition switch to the OFF/LOCK position. while the engine is running. Cycle the ignition