2013 Ford Explorer Owner Manual Printing 4 - Page 198

Universal Garage Door Opener (If Equipped) 197 Erasing the Function Button Codes Note: You cannot erase individual buttons. 1. Press and hold the outer two function buttons simultaneously for approximately 20 seconds until the indicator lights above the buttons flash rapidly. 2. When the indicator lights flash, release the buttons. The codes for all buttons are erased. Reprogramming a single button To program a device to a previously trained button, follow these steps: 1. Press and hold the desired button. Do NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the button, follow Step 1 in the Programming section. For questions or comments, contact HomeLink® at www.homelink.com or 1-800-355-3515. Programming HomeLink® to a Genie Intellicode® 2 garage door opener Note: The Genie Intellicode® 2 transmitter must already be programmed to operate with the garage door opener. Programing the transmitters To program HomeLink® to the transmitter you must first put the transmitter into programming mode. To do this: A. Red LED B. Green LED A B 1. Press and hold one of the buttons on the hand-held transmitter for 10 seconds. The LED light will change from green to green and red. 2013 Explorer (exp) Owners Guide gf, 4th Printing, November 2012 USA (fus)