2014 Ford Escape Owner Manual Printing 2 - Page 121

Universal Garage Door Opener (If Equipped) A E142660 E142661 B Red indicator light Green indicator light 1. Press and hold the outer two function buttons simultaneously for approximately 20 seconds until the indicator lights above the buttons flash rapidly. 2. When the indicator lights flash, release the buttons. The codes for all buttons are erased. Reprogramming a Single Button To program a device to a previously trained button, follow these steps: 1. Press and hold the desired button. Do NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the button, follow Step 1 in the Programming section. For questions or comments, contact HomeLink at www.homelink.com or 1-800-355-3515. Programming to a Genie Intellicode 2 Garage Door Opener Note: The Genie Intellicode 2 transmitter must already be programmed to operate with the garage door opener. Note: To program HomeLink to the transmitter you must first put the transmitter into programming mode. A. B. 1. Press and hold one of the buttons on the hand-held transmitter for 10 seconds. The indicator light will change from green to red and green. 2. Press the same button twice to confirm the change to programming mode. If done properly the indicator light will appear red. 3. Hold the transmitter within 1-3 inches (2-8 centimeters) of the button on the visor you want to program. 4. Press and hold both the programmed Genie button on the hand-held transmitter and the button you want to program. The indicator light on the visor will flash rapidly when the programming is successful. Note: The Genie transmitter will transmit for up to 30 seconds. If HomeLink does not program within 30 seconds the Genie transmitter will need to be pressed again. If the Genie transmitter indicator light displays green and red, release the button until the indicator light turns off before pressing the button again. Once HomeLink has been programmed successfully, the Genie transmitter must be changed out of program mode. To do this: 118 Escape/Kuga (TM2)