2014 Ford Escape Owner Manual Printing 2 - Page 223

Maintenance 6. Wipe any dirt or debris from the air filter housing and cover to make sure no dirt gets in the engine and to make sure you have a good seal. 7. Slide the open end of the air filter element in first, below the tab. Then push the closed end cap into the bottom of the tray. The closed end cap should fit inside the groove in the tray. The tab at the end of the closed end cap should be oriented down and fit between the forks on the tray. 8. Replace the air filter housing cover and secure the clips. 9. Reinstall the air cleaner assembly into the vehicle. 10. Reinstall the clean air tube assembly into the air cleaner assembly. 11. Tighten the air tube fastening screws. C D 25 feet (7.6 meters) Horizontal reference line Vehicles With Halogen Headlamps 1. Park the vehicle directly in front of a wall or screen on a level surface, approximately 25 feet (7.6 meters) away. 2. Measure the height of the headlamp bulb center from the ground and mark an 8 foot (2.4 meter) horizontal reference line on the vertical wall or screen at this height. Note: To see a clearer light pattern for adjusting, you may want to block the light from one headlamp while adjusting the other. 3. Turn on the low beam headlamps to illuminate the wall or screen and open the hood. ADJUSTING THE HEADLAMPS Vertical Aim Adjustment The headlamps on your vehicle are properly aimed at the assembly plant. If your vehicle has been in an accident, the alignment of your headlamps should be checked by your authorized dealer. E142465 E142592 4. On the wall or screen you will observe a flat zone of high intensity light located at the top of the right hand portion of the beam pattern. If the top edge of the high intensity light zone is not at the horizontal reference line, the headlamp will need to be adjusted. 8 feet (2.4 meters) Center height of lamp to ground A B 220 Escape/Kuga (TM2)