2014 Ford Explorer Owner Manual Printing 1 - Page 329

328 Maintenance If necessary, add fluid in 1/2 pint (250 ml) increments through the filler tube until the level is correct. MIN MAX If an overfill occurs, excess fluid should be removed by an authorized dealer. Note: An overfill condition of transmission fluid may cause shift and/or engagement concerns and/or possible damage. Do not use supplemental transmission fluid additives, treatments or cleaning agents. The use of these materials may affect transmission operation and result in damage to internal transmission components. For vehicles equipped with the EcoBoost engine, reinstall the air filter assembly. After the fluid level has been checked and adjusted as necessary, do the following: 1. Shut the engine off. 2. Loosen the clamp holding the air filter assembly to the rubber hose. 3. Rotate the air filter assembly 90 degrees clockwise without disconnecting the sensor. 4. Seat the air filter assembly back into the grommets by pushing down on the air filter assembly. 5. Tighten the clamp. 6. Install and tighten two bolts that attach air filter assembly to the front of the vehicle. 7. Install the bolt cover (if equipped). 8. Reinstall the harness retaining clip into the front of the air filter assembly. BRAKE FLUID CHECK Fluid levels between the MIN and MAX lines are within the normal operating range; there is no need to add fluid. If the fluid levels are outside of the normal operating range, the performance of the system could be compromised; seek service from your authorized dealer immediately. POWER STEERING FLUID CHECK Your vehicle is equipped with an electric power steering (EPS) system. There is no fluid reservoir to check or fill. For additional information on the electric power steering (EPS) system, Refer to Driving Aids. 2014 Explorer (exp) Owners Guide gf, 1st Printing, April 2013 USA (fus)