2014 Ford Explorer Owner Manual Printing 1 - Page 341

340 Maintenance Replacing front fog lamp bulbs 1. Make sure the headlamp switch is off. 1. Make sure that the fog lamp switch is in the off position. 2. Remove the bulb socket from the fog lamp by turning it counterclockwise. 3. Disconnect the electrical connector. Reverse steps to reinstall bulb(s). Replacing turn/backup lamp bulbs The turn/backup lamp bulbs are located in the same area of the tail lamp assembly, one below the other. Follow the same steps to replace these bulbs: 1. Make sure the headlamp switch is in the off position, then open the liftgate to expose the lamp assembly bolts. 2. Remove the two bolt covers using a standard flattip screwdriver. 3. Remove the two bolts from the lamp assembly. 4. Carefully remove the lamp assembly away from the vehicle by pulling the assembly straight out to expose the bulb socket. 5. Remove the bulb socket from the lamp assembly by turning it counterclockwise. 6. Pull bulb straight out of socket. 7. Install the new bulb in reverse order. Carefully install the tail lamp assembly on the vehicle by securing the lamp assembly with two bolts. Reinstall bolt covers. 2014 Explorer (exp) Owners Guide gf, 1st Printing, April 2013 USA (fus)