2014 Ford Explorer Owner Manual Printing 1 - Page 84

Locks 83 You may also program a personal entry code through the MyFord Touch or MyLincoln Touch system. Refer to the MyFord Touch or MyLincoln Touch chapter. Tips: • Do not set a code that uses five of the same number. • Do not use five numbers in sequential order. • The factory-set code will work even if you have set your own personal code. Erasing a Personal Code 1. Enter the factory-set 5-digit code. 2. Press and release 1•2 on the keypad within five seconds. 3. Press and hold 1•2 for two seconds. This must be done within five seconds of completing Step 2. All personal codes are now erased and only the factory-set 5-digit code will work. Anti-Scan Feature The keypad will go into an anti-scan mode if you enter the wrong code seven times (35 consecutive button presses). This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature will turn off after: • one minute of keypad inactivity • pressing the unlock button on the remote control • switching the ignition on • unlocking the vehicle using intelligent access. Unlocking and Locking the Doors To unlock the driver door: Enter the factory-set 5-digit code or your personal code. You must press each number within five seconds of each other. The interior lamps will illuminate. Note: All doors will unlock if the two-stage unlocking feature is disabled. Refer to Locking and Unlocking earlier in this chapter. To unlock all doors: Enter the factory-set code or your personal code, then press 3•4 within five seconds. To lock all doors: Press and hold 7•8 and 9•0 at the same time with the driver door closed. You do not need to enter the keypad code first. 2014 Explorer (exp) Owners Guide gf, 1st Printing, April 2013 USA (fus)