2014 Ford Explorer Owner Manual Printing 1 - Page 85

84 Locks Displaying the Factory Set Code With Integrated Keyhead Transmitters Note: You will need to have two programmed passive anti-theft keys for this procedure. To display the factory-set code in the information display: 1. Insert a key into the ignition and switch the ignition on for a few seconds. 2. Switch the ignition off and remove the key. 3. Insert the second key into the ignition and switch the ignition on. The factory-set code will display for a few seconds. Note: The code may not display until after any other warning messages first display. With Intelligent Access Keys Note: You will need to have two programmed intelligent access keys for this procedure. To display the factory-set code in the information display: 1. Place the first programmed key in the backup slot inside the center console. The key ring must be at the top with the buttons facing toward the rear. 2. Press the START/STOP button once and wait a few seconds. 3. Press the START/STOP button again and remove the key. 4. Insert the second programmed key into the backup slot, then press the START/STOP button. The factory-set code will appear in the information display for a few seconds. Note: The code may not display until after any other warning messages first display. 2014 Explorer (exp) Owners Guide gf, 1st Printing, April 2013 USA (fus)