2015 Ford F150 SuperCrew Cab Owner Manual Printing 1 - Page 155

Universal Garage Door Opener (If Equipped) Press and hold the HomeLink button while you press and release the hand-held transmitter button every 2 seconds. The HomeLink indicator light flashes slowly and then rapidly once the HomeLink function button recognizes and accepts the hand-held transmitter 's radio frequency signal. After programming the HomeLink button, begin programming your garage door opener motor. E188212 1. With your vehicle parked outside of the garage, switch your ignition to the on position, but do not start your vehicle. 2. Hold your hand-held garage door transmitter 1-3 inches (2-8 centimeters) away from the HomeLink button you want to program. 3. Using both hands simultaneously, press and hold the desired HomeLink button and the hand-held transmitter button. DO NOT release either one until the HomeLink indicator light flashes slowly and then rapidly. When the indicator light flashes rapidly, release both buttons. The rapid flashing indicates successful training. 4. Press and hold the programmed HomeLink button for five seconds, then release. You may need to do this twice to activate the door. If your garage door does not operate, watch the HomeLink indicator light. If the indicator light stays on, the programming is complete. See Programming Your Garage Door Motor later in this section. If the indicator light flashes rapidly for 2 seconds and then turns to a constant light, the HomeLink button is not programmed yet. Do the following: Note: You may need a ladder to reach the unit and you may need to remove the cover or lamp lens on your garage door opener. E142659 To program additional buttons, repeat Steps 1 - 4. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. Programming Your Garage Door Opener Motor 1. Press the learn button on the garage door opener motor and then you have 30 seconds to complete the next two steps. 2. Return to your vehicle. 152 F-150 (), enUSA, First Printing