2015 Ford F150 SuperCrew Cab Owner Manual Printing 1 - Page 156
2015 Ford F150 SuperCrew Cab Manual
Page 156 highlights
Universal Garage Door Opener (If Equipped) 1. Press and hold the desired button. Do NOT release the button. 2. The indicator light begins to flash after 20 seconds. Without releasing the button, follow Step 1 in the Programming section. For questions or comments, contact HomeLink at www.homelink.com or 1-800-355-3515. E188212 Programming to a Genie Intellicode 2 Garage Door Opener Note: Make sure to program your Genie Intellicode 2 transmitter with the garage door opener before you program the HomeLink buttons. Note: To program HomeLink to the transmitter you must first put the transmitter into programming mode. 3. Press and hold the function button you want to program for 2 seconds, then release. Repeat this step. Depending on your brand of garage door opener, you may need to repeat this sequence a third time. Erasing the Function Button Codes Note: You cannot erase individual buttons. A E142661 E188213 B Red indicator light. Green indicator light. A. B. 1. 1. Press and hold the outer two function buttons simultaneously for approximately 20 seconds until the indicator lights above the buttons flash rapidly. 2. When the indicator lights flash, release the buttons. You erased the codes for all buttons. Reprogramming a Single Button To program a device to a previously trained button, follow these steps: Press and hold one of the buttons on the hand-held transmitter for 10 seconds. The indicator light changes from green to red, and back to green again. 2. Press the same button twice to confirm the change to programming mode. If done properly, the indicator light appears red. 153 F-150 (), enUSA, First Printing