2003 Honda Accord Owner's Manual - Page 202

HomeLink Wireless Control System Canadian Owners: The remote control you are training may stop transmitting after two seconds. This is not long enough for HomeLink to learn the code. Release and press the button on the remote control every two seconds until HomeLink has learned the code. 5. The red light in HomeLink should begin flashing. It will flash slowly at first, then rapidly. 6. When the red light flashes rapidly, release both buttons. HomeLink should have learned the code from the remote control. 7. Plug in the garage door opener motor, then test the HomeLink button by pushing it. It should operate the garage door. If the button does not work, repeat this procedure to train it again. If it still does not work, you may have a variable or rolling code garage door opener. Test this by pressing and holding the HomeLink button you just trained. If the red light blinks for two seconds, then stays on, you have a rolling code garage door opener. You may be able to verify this with the manufacturer's documentation. Go to ''Training With a Rolling Code System.'' 8. Repeat these steps to train the other two HomeLink buttons to operate any other remotelycontrolled devices around your home (lighting, automatic gate, security system, etc.). Training With a Rolling Code System For security purposes, newer garage door opening systems use a ''rolling'' or variable code. Information from the remote control and the garage door opener are needed before HomeLink can operate the garage door opener. The ''Training HomeLink'' procedure trains HomeLink to the proper garage door opener code. The following procedure synchronizes HomeLink to the garage door opener so they send and receive the correct codes. 200 Comfort and Convenience Features