2015 Jeep Grand Cherokee Owner Manual SRT - Page 250

248 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator To reprogram a channel that has been previously trained, light in view. follow these steps: 3. Push and hold the Homelink® button you want to 1. Cycle the ignition to the ON/RUN position. program while you push and hold the hand-held 2. Push and hold the desired HomeLink® button until transmitter button. the indicator light begins to flash after 20 seconds. Do 4. Continue to hold both buttons and observe the indinot release the button. cator light. The Homelink® indicator will flash slowly 3. Without releasing the button proceed with "Programand then rapidly after HomeLink® has received the ming A Rolling Code" step 2 and follow all remaining frequency signal from the hand-held transmitter. Resteps. lease both buttons after the indicator light changes from slow to rapid. Programming A Non-Rolling Code For programming Garage Door Openers manufactured 5. Push and hold the programmed HomeLink® button and observe the indicator light. before 1995. • If the indicator light stays on constantly, program1. Place the ignition in the ON/RUN position. ming is complete and the garage door/device should activate when the HomeLink® button is pushed. Reprogramming A Single HomeLink® Button (Rolling Code)