2015 Jeep Grand Cherokee Owner Manual SRT - Page 329

UNDERSTANDING YOUR INSTRUMENT PANEL 327 activated in "Lights" mode. When this mode is selected, the Blind Spot Monitor (BSM) system is activated and will only show a visual alert in the exterior mirrors. When "Lights & Chime" mode is activated, the Blind Spot Monitor (BSM) will show a visual alert in the exterior mirrors as well as an audible alert when the turn signal is on. When "Off" is selected, the Blind Spot Monitor (BSM) system is deactivated. To change the Blind Spot Alert status, press the "Off," "Lights" or "Lights & Chime" button on the touchscreen. Then press the back arrow button on the touchscreen. Your vehicle may be equipped with the ParkView® Rear Back Up Camera Active Guidelines that allows you to see active guidelines over the ParkView Back up camera display whenever the shift lever is put into REVERSE. The image will be displayed on the radio touchscreen display along with a caution note to "check entire surroundings" across the top of the screen. After five seconds, this note will disappear. To change the mode status, press the "ParkView Backup Camera Active Guidelines" button on the touchscreen, until a check-mark appears NOTE: If your vehicle has experienced any damage in next to setting, indicating that the setting had been the area where the sensor is located, even if the fascia is selected. Press the back arrow button on the touchscreen not damaged, the sensor may have become misaligned. to return to the previous menu. Take your vehicle to an authorized dealer to verify sensor • ParkView® Backup Camera Delay alignment. Having a sensor that is misaligned will result When the vehicle is shifted out of REVERSE (with camera in the BSM not operating to specification. delay turned OFF), the rear camera mode is exited and the navigation or audio screen appears again. When the • ParkView® Backup Camera Active Guidelines 4